NEC NLT-19HDDV3 - Connection of PC; PC Setup; WXGA or VGA (Only PC-RGB Mode)

60
Connection of PC
PC Setup
You can adjust horizontal/vertical position, clock,
phase, and auto-configure, reset as you prefer.
Press the MENU button and then
DD
/
EE
button to
select the SETUP menu.
Press the G button and then
D
/
E
button to select
PC-Control.
Press the GG button and then
DD
/
EE
button to select
the desired picture item.
Press the
FF / GG button to make appropriate adjust-
ments.
H-Position / V-Position
This function is to adjust picture to left/right and
up/down as you prefer.
Clock
This function is to minimize any vertical bars or
stripes visible on the screen background. And the
horizontal screen size will also change.
Phase
This function allows you to remove any horizontal
noise and clear or sharpen the image of characters.
Auto
This function is for the automatic adjustment of the
screen position, clock and phase. The displayed
image will disappear for a few seconds while the
Auto-configuration is in progress.
Reset
This function allows you to return to the good pic-
ture reproduction programmed at the factory and
cannot be changed.
Note : Some signal from some graphics boards
may not function properly. If the results are unsat-
isfactory, adjust your monitor’s position, clock and
phase manually.
Press the OK button to store it for the PC monitor
picture.
Press the EXIT button to return to PC mode.
E DD
F G OK MENU
SETUP
H-Pos. 0
V-Pos. 0
Clock 0
Phase 0
Auto
Reset
Language
Input
ARC
PC-Control
WXGA
VGA
Child lock
New password
Language
Input
ARC
PC-Control
WXGA
VGA
Child lock
New password
E DD
G OK MENU
SETUP
WXGA or VGA (Only PC-RGB mode)
a : When the set is inputted WXGA signal, select
the desired WXGA resolution.
b : When the set is inputted 480p and 720p signal
in VGA mode, select 480p and 720p on the
SETUP menu.
E DD
F G OK MENU
SETUP
1024X768
1280X768
1360X768
1366X768
Language
Input
ARC
PC-Control
WXGA
VGA
Child lock
New password