NEC NP-PH3501QL - Attaching the Power Cable Stopper

18
2. Projecting an Image (Basic Operation)
Attaching the power cable stopper
Topreventthe power cable fromaccidentlyremovingfromtheACINofthe projector, attach the supplied power cable
stopper to clamp the power cable.
CAUTION
•
Topreventthepowercablefromcomingloose,makesurethatalltheprongsofthe power cable are fully inserted
into theACINterminalof the projector beforeusingthepowercablestoppertoxthepowercable.Aloose
contact of the power cable may causeareorelectricshock.
• Do not bundle the power cable. Doingthiscouldcauseheatorare.
NOTE
•
 Donotclampthepowercablewithothercables.Doingsocangeneratenoise,whichcanaffectadverselythesignalcable.
• Becarefulnottoinsertthebandinversely.Oncethebandisattached,itcannotberemovedfromtheslot.
1. Set the clamper band to the power cable side, and
insert the e
ndofbandofthepower cable stopper into
the slot next to
theACINontheterminal panel.
Attach the power cable stopper to the other side in the
same way.
2. Pass each band through the slits in the power cable
stopper.
Pass the bands through them so that the power cable will
be sandwiched from above and below.
Band
3. Slide the clampertothehiltof the power cable.
Pulling the knob in the arrow direction allows you to adjust
the clamper position.
Once the clamper position is adjusted, release the knob
to lock the clamper.
Knob