NEC NP-PH3501QL - ❹ Turning On The Projector

21
2. Projecting an Image (Basic Operation)
❹ Turning on the Projector
Please contact your dealer/distributor to connect the power cable.
Preparation:
• Connectthepowercabletotheprojector.(→page17)
• SupplyACpowertotheprojector.
NOTE:
• TurnofftheprojectorpowerswitchandlightpowerswitchtotheprojectorwhensupplyingorcuttingACpowertotheprojector.
SupplyingorshuttingdowntheACpowerwhiletheprojectorpowerswitchandlightpowerswitchisonwilldamagetheprojector.
• Turningonandofftheprojectorinvolvesatwo-stepoperation;the“projectorpowerswitchandlightpowerswitch”andthe
“POWERbutton”(POWERONandOFFontheremotecontrol).
Turningpoweron.(Seethispage)
1. Turnonthe“projectorpowerswitchandlightpowerswitch”oftheprojector.
Your projector is set in a standby state.
2. Press the (POWER)buttonontheprojectorcabinetorthePOWERONbuttonontheremotecontrol.
Your projector is turn on.
Turningpoweroff.(→ page 34)
1. Press the (POWER) button on the projector cabinet or the POWER OFF button on the remote control.
The confirmation message will be displayed.
2. Press the (POWER) button or the POWER OFF button again.
Your projector is set in a standby state.
3. Turnoffthe“projectorpowerswitchandlightpowerswitch”oftheprojector.
Your projector is turned off.
1. Remove the lens cap.
2. Inserttheadministratorkeyhorizontallyandturnittotheverticaldirection.
The administrator key can no longer be removed. The projector will not function unless the administrator key is
inserted.
Administrator switch
Administrator key