NEC NP110 - Correcting Keystone Distortion; Adjusting with Buttons on the Cabinet

24
3. Projecting an Image (Basic Operation)
 Correcting Keystone Distortion
Correcting Keystone Distortion
If the screen is tilted vertically, keystone distortion becomes large. Proceed with the following
steps to correct keystone distortion
NOTE:
• TheKeystonecorrectioncancauseanimagetobeslightlyblurredbecausethecorrectionismadeelectronically.
• TheKeystonecorrectionrangecanbemadenarrower,dependingonasignaloritsaspectratioselection.
Adjusting with buttons on the cabinet
1. Press the ( ) or ( ) button with no menus displayed.
The keystone bar will be displayed.
2. Use the  or  to correct the keystone distortion.
Adjust so that the right and left sides are parallel.
3. Press the ENTER button.
The keystone bar will be closed.
NOTE:Whenthemenuisdisplayed,theaboveoperationisnotavailable.Whenthemenuisdisplayed,presstheMENUbuttonto
closethemenuandstarttheKeystonecorrection.
Fromthemenu,select[SETUP]→[GENERAL]→[KEYSTONE].Thechangescanbesavedwith[KEYSTONESAVE].(→ page 55)