NEC NP110 - Menu Descriptions & Functions [RESET]

68
5. Using On-Screen Menu
 Menu Descriptions & Functions [RESET]
[NP210/NP115/NP110] [NP216/NP215]
ReturningtoFactoryDefault[RESET]
The RESET feature allows you to change adjustments and settings to the factory preset for a (all) source (s) except
the following:
[CURRENTSIGNAL]
Resets the adjustments for the current signal to the factory preset levels.
Theitemsthatcanberesetare:[PRESET],[CONTRAST],[BRIGHTNESS],[COLOR],[HUE],[SHARPNESS],
[ASPECTRATIO],[HORIZONTAL],[VERTICAL],[CLOCK],[PHASE],[NOISEREDUCTION],and[TELECINE].
[ALLDATA]
Reset all the adjustments and settings for all the signals to the factory preset.
All items can be reset EXCEPT [LANGUAGE], [BACKGROUND],[SECURITY], [COMMUNICATION SPEED],
[CONTROLID],[STANDBYMODE],[FANMODE],[CONTROLTERMINAL](NP216/NP215only),[LAMPLIFE
REMAINING],[LAMPHOURSUSED],[TOTALCARBONSAVINGS],and[NETWORKSETTINGS](NP216/NP215
only).
Toresetthelampusagetime,see“ClearingLampHourMeter[CLEARLAMPHOURS]”below.
ClearingNetworkingSettings[NETWORKSETTINGS](NP216/NP215only)
Returns[DHCP],[IPADDRESS],[SUBNETMASK],and[GATEWAY]tothedefaultsettings.
ClearingLampHourMeter[CLEARLAMPHOURS]
Resetsthelampclockbacktozero.Selectingthisoptiondisplayssubmenuforaconrmation.Select[YES]andpress
the ENTER button.
NOTE:Elapsedtimeofthelampusewillnotbeaffectedevenwhen[RESET]isdonefromthemenu.
NOTE:Theprojectorwillturnoffandgointostandbymodewhenyoucontinuetousetheprojectorforanother100hoursafterthe
lamp has reached the end of its life. In this condition you cannot clear the lamp hour meter on the menu. If this happens, press the
HELPbuttonontheremotecontrolfor10secondstoresetthelampclockbacktozero.Dothisonlyafterreplacingthelamp.