NEC NP110 - Page 63

54
5. Using On-Screen Menu
TurningonNoiseReduction[NOISEREDUCTION]
This function allows you to select the level of noise reduction.
Theprojectorissettotheoptimizedlevelforeachsignalatthefactory.
Select your preference item for your signal when video noise is noticeable.
Theoptionsare[OFF],[LOW],[MEDIUM],and[HIGH].
NOTE:ThisfeatureisnotavailablefortheRGBsignal.Noisereductionsettooffgivesbestimagequalitybywayofhigherbandwidth.
Noise reduction set to on softens the image.
SettingTelecineMode[TELECINE]
This function allows you to convert motion picture film images into video. The process adds additional frames to the
picture in order to increase the frame rate.
NOTE:ThisfeatureisavailableonlywhenanSDTVsignalisselected.
OFF ........................ Turns off the TELECINE mode.
2-2/2-3 AUTO
........ Detects pull-down correction method.
2-2 ON
................... Uses 2-2 pull-down correction method
2-3 ON
................... Uses 2-3 pull-down correction method
NOTE:Thisfeatureisnotavailablefor480p,576p,720p,1080iandRGBsignals.