NEC NP43 - Optimizing RGB Picture Automatically

27
3. Projecting an Image (Basic Operation)
＋
AUTO
ADJ.
ON/STAND BY
FOCUS
LAMP
STATUS
POWER
SOURCE
[Poor picture]
[Normal picture]
➏
Optimizing RGB Picture Automatically
Adjusting the Image Using Auto Adjust
Thisadjustmentmaybenecessarywhenyouconnectyourcomputerforthersttime.
Adjusting with buttons on the cabinet
• Pressthe◀buttonwithnomenusdisplayed.
 AnRGBimagewillbeoptimizedautomaticallyafterafewseconds.
Adjusting with the remote control
• PresstheAUTOADJ.buttontooptimizeanRGBimageautomatically.
NOTE:
Somesignalsmaytaketimetodisplayormaynotbedisplayedcorrectly.
• NP63/NP43:TheAutoAdjustfunctiondoesnotworkforcomponentandvideosignals.
• NP64/NP54:TheAutoAdjustfunctiondoesnotworkforcomponent/videosignals,andtheViewersource.
• IftheAutoAdjustoperationcannotoptimizetheRGBsignal,trytoadjustHORIZONTAL/VERTICAL,CLOCKandPHASEmanu-
ally.(→page60,61)
• IfperformingtheAutoAdjustfunctiondoesnotcorrectimagepositioning,verticalstripes(banding)orhorizontalnoise,per-
formthe[HORIZONTAL],[VERTICAL],[CLOCK]or[PHASE]functionfromthemenutooptimizetheimage.(→page60,61)
• Performingthe [HORIZONTAL],[VERTICAL],[CLOCK]or[PHASE] function willstorethe adjustment values of the currently
projectedsourceintotheprojector’smemory.
• Thenexttimethesamesource(sameresolution,horizontalandverticalfrequencies)isprojected;theprojectorwillcallup
frommemorythestoredvaluesforthesource.
• Toclearthestoredadjustmentvalues,selectthe[RESET]→[CURRENTSIGNAL]or[ALLDATA]fromthemenutoresetthe
adjustmentvalues.