NEC P506QL - Starting and Shutting down the Projector

2 Setup and Operation
– 12 –
2-2 Starting and Shutting down the Projector
1.
Securely connect the power cord and signal
cable. When connected, the power led will
flash green to solid green.
2.
Turn on the light source
remote control.
The PWR LED will now flash blue.
The startup screen will display in
approximately 30 seconds. The first time
you use the projector, you can select your
preferred language from quick menu after
the startup screen display. (See Setting the
OSD Language on page 20)