6. Using the VIEWER
96
6-2. Projecting the pictures on a USB memory (basic operation)
This section explains the basic operations of the [VIEWER]. This is the operating procedure when the
option menu (→ page 103) of the [VIEWER] is in the default state when shipped from the factory.
① Start the [VIEWER]
1. Turn on the projector.
USB
2. Insert a USB memory into the USB-A port of
the projector.
NOTE:
• To remove a USB memory from the projector, press the
MENU button in the file list screen or [DRIVE LIST] screen and
select [REMOVE USB DEVICE]. (→ Page 98 “Remove the USB
memory”)
3. Press the INPUT button.
The [INPUT] screen is displayed.
• Press the SOURCE button when using the
remote control.
4. Press the INPUT button a few times and move
the cursor to [USB-A].
• Every time the INPUT button is pressed
briefly, the cursor moves to the next input
terminal.
• Move the cursor to [USB-A] and wait for
a while for the [VIEWER] to start and the
[DRIVE LIST] screen on the USB memory to
be projected.
5. Check that the cursor is moved to [USB 1] and
press the ENTER button.
The file list screen will be displayed.
To Next Page
Loading...
