NEC P525UL User Manual

9. Appendix
144
9-10. Setting the date and time in the projector
Set the current date and time and daylight saving time in the projector. When set, the date and time
appear in the upper right corner of the MultiPresenter start-up screen.
There are 2 ways of displaying the screen for [DATE AND TIME SETTINGS] as shown below.
1. Display the on-screen menu and select [SETUP] → [GENERAL] → [DATE AND TIME SETTINGS].
(NOTE: At this point, the input terminal switches to [LAN]. )
2. Switch the input terminal to [LAN], display the “MultiPresenter start-up screen” and select [TOOLS]
→ [DATE AND TIME].
Item name Description
TIME ZONE SETTINGS Set the time difference between the region where the projector is used and the UTC (Universal
Time, Coordinated).
• Initial value: +00:00
• When using the projector in Japan, set the time as [+09:00].
DATE AND TIME SETTINGS Sets the current date and time.
• When shipped from the factory, the time is set to the UTC (Universal Time, Coordinated). By
setting the time zone of your area, the current date and time will be displayed.
• When synchronizing the time with the NTP server on the network to obtain the correct time, set
[SYNCHRONIZE TO INTERNET TIME SERVER.] to [ENABLE]. Then enter the IP address of the NTP
server or the [HOST NAME] and perform [UPDATE].
SUMMER TIME SETTINGS Set the daylight saving time.
• Set the daylight saving time setting to [ENABLE].
• Set the start and end of the daylight saving time, as well as each item of the time difference.

NEC P525UL Specifications

General

Native aspect ratio	16:10
Projection distance	0.762 - 7.62 m
Projection technology	3LCD
Contrast ratio (dynamic)	520000:1
Contrast ratio (typical)	-
Screen size compatibility	30 - 300 \
Projector native resolution	WUXGA (1920x1200)
Keystone correction, horizontal	-30 - 30 °
Projector brightness (economic mode)	3000 ANSI lumens
Light source type	Laser
Service life of light source	20000 h
Zoom capability	Yes
Focal length range	- mm
Vertical lens shift range	0 - 60 °
Horizontal lens shift range	-29 - 29 °
DVI port	No
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Noise level	26 dB
Certification	CE; EAC; ErP; TUEV Type Approved; TüV GS
Number of OSD languages	30
Noise level (economic mode)	22 dB
Analog signal format system	NTSC 3.58, NTSC 4.43, PAL, PAL 60, PAL M, PAL N, SECAM
Power source	AC
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.3 W
Power consumption (typical)	330 W
Power consumption (economy mode)	240 W
Storage temperature (T-T)	-10 - 50 °C
Operating temperature (T-T)	5 - 40 °C
Operating relative humidity (H-H)	20 - 80 %
Sustainability certificates	RoHS
RMS rated power	20 W
Placement	Ceiling, Floor
Product type	Standard throw projector
Product color	White
Cable lock slot type	Kensington
Harmonized System (HS) code	85286200

Weight and Dimensions

Depth	407 mm
Width	480 mm
Height	122 mm
Weight	9700 g