2. Projecting an Image (Basic Operation)
31
2-9. Turning off the Projector
To turn off the projector:
1. First, press the (POWER) button on the
projector cabinet or the STANDBY button on
the remote control.
The confirmation message will be displayed.
• The confirmation message displayed when
the power is turned off indicates the amount
of CO
2
reduction this session (→ page 36).
2. Secondly, press the ENTER button or press
the (POWER) or the STANDBY button
again.
When the light source turns off, the power turns
off too (standby mode).
When the projector goes into the standby
mode, the POWER indicator of the unit flashes
orange. (In the state, [STANDBY MODE] is
[NORMAL].)
Power On
Steady blue light
Standby
Blinking orange light
3. Mount the lens cap.
Insert the cap’s 2 (two) hooks into the grooves
of the projector, then press at the bottom of the
lens cap. The stopper is secured to the projector.
Hook
Stopper
To Next Page
Loading...
