6. Using the VIEWER
99
5. Remove the USB memory from the projector.
NOTE:
• If you remove a USB memory from the projector without
executing [REMOVE USB DEVICE] in the menu, the operation
of the unit may become unstable. In that case, turn off the
power of the unit once and unplug the power cord from the
outlet.
Subsequently, wait for about 3 minutes before connecting
the power cord to the socket and turning on the power of
the unit.
USB
③ End the [VIEWER]
1. Press the MENU button in the slide screen or
file list screen.
A control bar or a pop-up menu will be dis-
played.
2. Press the MENU button again.
The [INPUT] screen is displayed.
3. Move the cursor to an input terminal other
than [USB-A] and press the ENTER button.
The [VIEWER] will end.
TIP:
• When using the remote controller, press the HDMI1 button etc. to end the [VIEWER].
To Next Page
Loading...
