7. Connecting to a Network
113
⑥ NETWORK SERVICE
Configure the [AMX BEACON], [Extron XTP], [HTTP SERVER], [PJLink], [ALERT MAIL], [CRESTRON]
and other settings.
Item name Description
AMX BEACON Select whether or not to transmit AMX beacons.
• Initial value: OFF (do not transmit)
Extron XTP Choose whether to enable or disable the connection with the Extron XTP device.
• Initial value: OFF (disable)
HTTP SERVER Set the password to log into the projector’s HTTP server.
• Initial value: Blank
• Allowable characters: Alphanumeric symbols
• Number of characters: 0–10 characters
When a password is set, a number of asterisks “*” equivalent to the number of
characters is displayed.
PJLink Set the PJLink password.
PASSWORD SETTINGS Set the PJLink password.
• Initial value: Blank
• Allowable characters: Alphanumeric characters
• Number of characters: 0–32 characters
When a password is set, a number of asterisks “*” equiva-
lent to the number of characters is displayed.
ALERT MAIL Set alert mail and perform a transmission test.
ALERT MAIL Select whether or not to send an alert mail when an alert
target event occurs in the projector.
• Initial value: OFF (do not transmit)
SENDER'S ADDRESS Set the sender’s address when sending E-mail from the
projector.
• Initial value: Blank
• Allowable characters: Alphanumeric characters, sym-
bols
• Number of characters: 0–60 characters
SMTP SERVER NAME Set the SMTP server of the network to connect to the
projector.
• Initial value: Blank
• Allowable characters: Alphanumeric characters, sym-
bols
• Number of characters: 0–60 characters
RECIPIENT'S ADDRESS
1/2/3
Set the destination address to send E-mail from the
projector (maximum 3).
• Initial value: Blank
• Allowable characters: Alphanumeric characters, sym-
bols
• Number of characters: 0–60 characters
TEST MAIL Send a test mail according to the settings.
To Next Page
Loading...
