9. Appendix
142
Indicator Message (Error message)
POWER STATUS LIGHT Projector status Procedure
A button has been pressed while
the [CONTROL PANEL LOCK] is
activated.
The projector’s keys are locked.
The setting must be canceled to
operate the projector. (→ page
69)
Blue
(Light)
Orange
(Light)
Status varies
ID numbers for the projector and
the remote control do not match.
Check the control IDs (→ page 70)
Network conflict Both the built-in wired LAN and
the wireless LAN cannot be con-
nected to the same network at
the same time.
To use both built-in wired LAN
and wireless LAN at the same
time, connect them to different
networks.
NOTE: In the Standby condition,
the status indicator on the cabi-
net does not blink in orange even
if the network conflicts.
Blue
(Light)
Orange
(Blink*
4
)
Status varies
Temperature problem (In the
Forced ECO mode)
Ambient temteprature is high.
Lower the room temperature.
Blue
(Light)
Off Orange
(Light)
Temperature problem Ambient temperature is out of
the operation temperature. Check
if any obstruction stays near the
exhaust vent.
Red
(Blink*
3
)
Off Off
Hardware problem Problem with the hardware.
Contact your dealer.
Status varies Off Red
(Blink*
3
)
Error requiring service support Contact your dealer or service
personnel. Make sure to check
and inform indicator status for
asking to repair.
Red
(Light)
Status varies Status varies
*3 Repetition to light on for 0.5 seconds / off for 0.5 seconds
*4 Repetition to light on for 0.5 seconds / off for 2.5 seconds
To Next Page
Loading...
