Important Information
xvii
• Take measures to prevent external light from shining on the screen.
Make sure only the light from the projector shines on the screen. The less external light on the
screen, the higher the contrast and the more beautiful the images.
• About screens
Images will not be clear if there is dirt, scratches, discoloration, etc. on your screen. Handle the
screen with care, protecting it from volatile substances, scratches and dirt.
Clearance for Installing the Projector
When installing the projector, keep sufficient space around it, as described below. If not, the hot
exhaust emitted from the projector may be taken back in.
Also, make sure no wind from an air-conditioner hits the projector.
The projector’s heat control system may detect an abnormality (temperature error) and automati-
cally shut off the power.
20 cm/8" or greater
Exhaust vent
Wall
NOTE:
• In the above figure, it is assumed that there is sufficient space above the projector. There is also an intake vent on the back. Leave
enough space behind to install the cables.
To Next Page
Loading...
