To Next Page

To Previous Page

129

5. Using On-Screen Menu

[POWER OPTIONS]

Selecting Power-saving in [STANDBY MODE]

Settingthepowerconsumptioninthestandbymode.

NORMAL �� In the standby mode, the power consumption of the projector is 0�11 W (100-130 V)/0�16 W (200-

240 V)�

In the standby mode, the POWER indicator lights up in red while the STATUS indicator will go off�

• Whensetto[NORMAL],thefollowingterminalsandfunctionswillbedisabled.HDMIoutputterminal,

Audio output terminal, Ethernet/HDBaseT port (Ethernet port for MM models), USB-A port, LAN function,

[ALERT MAIL] function

HDBaseT STANDBY (HDBaseT Models)/NETWORK STANDBY (MM Models)

�� Compared to [NORMAL], the power consumption in the standby mode is higher but power can be supplied

to the projector using a wired LAN�

In the standby mode, the power indicator will light up in orange while the status indicator will be turned

off�

Important:

• When[HDBaseTSTANDBY]([NETWORKSTANDBY]forMMmodels)isselected,[AUTOPOWEROFF]turnsgreyincolourand

becomesdisabledwhile[0:15]isselectedcompulsorily.

• Whenitissetto[HDBaseTSTANDBY]([NETWORKSTANDBY]forMMmodels),underthefollowingconditions,the[STANDBY

MODE]settingisdisabledandtheunitwillgointothesleepmode*.

* Sleepmodereferstothemodewherebythefunctionalrestrictionsduetothe[STANDBYMODE]settingareremoved.

• When[ENABLE]isselectedunder[NETWORKSERVICE]→[AMXBEACON]

• When[NETWORKSERVICE]→[CRESTRON]→[CRESTRONCONTROL]→[ENABLE]isselected

• When[CONTROL]→[REMOTESENSOR]→[HDBaseT]isselected(onlyforHDBaseTmodels)

• SignalbeingreceivedfromtheHDBaseTtransmissiondevice(onlyforHDBaseTmodels)

• When[NORMAL]isselected,the[AUTOPOWERONSELECT]displayturnsgreyincolorandisdisabled,and[OFF]isautomati-

cally selected.

NOTE:

[HDBaseTModels]

• WhenconnectingtoaHDBaseTtransmissiondevicesoldcommercially,ifthetransmissiondeviceissettotransmitremotecontrol

signals, the power consumption of the projector in the standby mode will increase.

TIP:

• Yoursettingwillnotbeaffectedevenwhen[RESET]isdonefromthemenu.

• ThepowerconsumptioninthestandbymodewillnotbeincludedincalculatingCO

emission reduction.

Enabling Direct Power On [DIRECT POWER ON]

Turnstheprojectoronautomaticallywhenthepowercordisinsertedintoanactivepoweroutlet.Thiseliminatesthe

needtoalwaysusethePOWERbuttonontheremotecontrolorprojectorcabinet.

NEC PA621X User Manual

Other manuals for NEC PA621X