NEC PA621X - Page 185

171
6. Installation and Connections
1. Press the button to set the projector to the standby
mode, then disconnect the power cord.
 Waitfortheprojectortofullycooloff.
2. Press down on the buttons on the left and right and then
pull the filter cover towards you to open it.
 Thecoverwillopenabout90degreesbeforeitstops.
Filtercover Button
3. Remove the filter unit by pulling out the tab.
Filterunit Tab
4. Slowly insert the wireless LAN unit into the USB (LAN)
port.
• RemovethewirelessLANunit’scap,settheunitwiththe
front(thesidewiththeindicator)facingupwards,holdthe
backedgeandinserttheunitgently.
 Next,pressthewirelessLANunitinwithanger.
• Thecapyouhaveremovedwillbeusedwhenthewireless
LANunitisremoved,sostoreitinasafeplace.
NOTE:IfthewirelessLANunitishardtoinsert,donotpushitinby
force.
WIRELESS
WIRELE
SS
WirelessLANunit
5. Mount the filter unit back onto the projector cabinet.
 Insertthelterunitontotheprojectorwiththesidesonwhich
theleftandrighthooksarelocatedontheoutside.
Hook