NEC PX602WL - Terminals Features

8
1. Introduction
Terminals Features
9 7
1
4
238
1312
1011
56
1. COMPUTER1IN/ComponentInputTerminal
(MiniD-Sub15Pin)
(→page13,125,131,166)
2. DisplayPortINTerminal(DisplayPort20Pin)
(→page126,166)
3. HDMIINTerminal(TypeA)
(→page126,128,132,166)
4. BNCInput[R/Cr/CV,G/Y/Y,B/Cb/C,H,V]Termi-
nals(BNC×5)
(→page125,130)
5. BNC(Y/C)InputTerminal(BNC×2)
(→page130)
6. BNC(CV)InputTerminal(BNC×1)
(→page130)
7. USBPort(TypeA)
(→page167)
 (Forfutureexpansion.Thisportallowsforpowersup-
ply.)
8. HDMIOUTTerminal(TypeA)
(→page129)
9. Ethernet/HDBaseTPort(RJ-45)
(→page133,134,167)
10.3DSYNCTerminal(MiniDIN4Pin)
(→page40)
11.PCCONTROLPort(D-Sub9Pin)
(→page167,173)
 Use this port to connect a PC or control system.
Thisenablesyoutocontroltheprojectorusingserial
communicationprotocol.Ifyouarewritingyourown
program,typicalPCcontrolcodesareonpage173.
12.REMOTETerminal(StereoMini)
 Usethisjackforwiredremotecontroloftheprojector
usingacommerciallyavailableremotecablewith⌀3.5
stereomini-plug(withoutresistance).
 Connecttheprojectorandthesuppliedremotecontrol
usingacommerciallyavailablewiredremotecontrol
cable.
(→
page11)
NOTE:
• WhenaremotecontrolcableisconnectedtotheREMOTE
terminal, infrared remote control operations cannot be per-
formed.
• PowercannotbesuppliedfromtheREMOTEterminaltothe
remote control.
• When [HDBaseT] is selected in the [REMOTE SENSOR]
and the projector is connected to a commercially-available
transmissiondevicethatsupportsHDBaseT,remotecontrol
operations in infra-red cannot be carried out if transmission
of remote control signals has been set up in the transmission
device.However,remotecontrolusinginfraredrayscanbe
carried out when the power supply of the transmission device
is switched off.
13. SLOT
(→page157)