CHAPTER 4 EQUIPMENT DESCRIPTION
UNIVERGE NEAX 2000 IPS General Description Page 97
Issue 5
Line/Trunk (LT) Cards (Cont.)
Abbrev Name Code Ports Remarks
8RST PN-8RSTG 8 8-line PB Receiver Card
Used for a PB station line, DID or tie line.
4RST PN-4RSTF-A 4 4-line Sender Card for Caller ID Display on analog
Single Line Telephones PN-4LLCB is required.
DAT PN-4DATC 8 4-line Digital Announcement Trunk Card
Recording duration: Maximum 120 seconds
Occupies 8 time slots per one card.
DK00 PN-DK00 0 8-circuit External Relay Control/External Key Scan
Card. Provides the above-mentioned control
functions on a per circuit basis.
TNT PN-TNTA 4 2-line Tone/Music Source Interface Card
Used for BGM or Music on Hold.
Provides two jacks for an external tone/music
source.
SPN-4VCTI-B 4 4-channel CODEC Card for IP Trunk Card
Provides voice compression DSP control functions
such as voice compression control, DTMF relay and
FAX relay.
• Voice compression protocols: G.711 (64 Kbps),
G.723.1 (5.3 Kbps/6.3 Kbps), G.729a (8 Kbps)
• FAX protocol: T.30
Used together with IP Trunk (PN-IPTB) card.
Four cards can be accommodated per IP Trunk (PN-
IPTB) card, maximum 32 per system.
VCT
SPN-4VCTI-B
(H.323)
4 4-channel voice translator CODEC card for H.323
includes BUS cable. Voice compression: G729A
/G723 /G711. Up to qty 3 are used with one SPN-
IPTB-B (H323) to provide 12 IP Trunk Channels.
Max 3 VCT’s per each IPT, max 32 VCT’s per
system. VCT cards connect together and to IPT via
front connected bus cable. One cable is included
with each VCT card.
CSI SPN-4CSIA 16 4-line Zone Transceiver Interface Card
Used to interface with the ZT, based on U-interface.
Maximum four ZTs can be connected per CSI card.
Occupies 16 time slots per one card.
Optical
Modem
PN-M10 0
Optical Fiber Interface Card
Provides optical fiber interface for T1/E1 Digital
Trunk Interface (1.5 M/2 Mbps)
Line length : 10 km (6.2 miles) or less
Line coding : CMI
PZ-8PFTB 0
8-line Power Failure Transfer Card
To be mounted in PFT slot of PIM.
One card per PIM.
PFT
PZ-4PFTA
0
4 Circuit Power Fail Transfer (PFT).
Mounts in each IPS DM (E) IPSMJ (includes
mounting hardware and POWER CA-PFT.)
To Next Page
Loading...
