NEC UNIVERGE NEAX 2000 IPS - Ip Remote Network Capacity

CHAPTER 7 SPECIFICATIONS
UNIVERGE NEAX 2000 IPS General Description Page 174
Issue 5
IP Remote Network Capacity
Total System Capacity (Main plus Remote)
Item Capacity
LT Ports 1020
AP Ports 256 per site
Analog Single Line Tel. + Dterm (all stations) 980
IP PAD (No. of Channel) 256
DtermIP/INASET (PTP Connection) 952
PS 512
Zone Transceiver (ZT)
128
ISDN Terminal
64
Central Office Trunk (Lines) 256
Tie Line Trunk (Lines) 2W/4W E&M 192
CCIS Trunk (Peer to Peer Connection) 127
DTI/CCIS Digital Link 1.5M/2M DTI: 10/CCIS: 8 Links
1.5M (PRT) 8 Main / 32 Total
ISDN
4BRT (card) 24
IP Trunk 8
PFT Connections 64
3-Party Conference Max. 16 conference groups
8-Party Conference Group Max. 8 conference groups
32-Party Conference Max. 8 conference groups
DTMF Sender/Receiver Max. 32 circuits
Attendant Consoles 8
Attendant Terminal (Dterm ATT Position) Max. 8 sets
SMDR Interface
Max. 2 interface ports per system (RS-232C)
Max.1 port per system (IP)
PMS Interface
Max. 1 interface port (RS-232C)
/ Max. 1 interface port (IP) -per system
ACD / MIS or OAI Interface Max. 1 interface port
Remote PIM over IP Up to 30 (depending on network)
DID Dial Conversion 1000
Call Forwarding-Outside Set 496
Authorization Code / Forced Account Code /
Remote Access to System(DISA)Code
3000
Message Reminder Set 1024
Name Display / Guest Name Display 512
Speed Calling-Station (Station Speed Dial) Set 10000
MP built-in SMDR Call Record 1024