CHAPTER 1 INTRODUCTION
UNIVERGE NEAX 2000 IPS General Description Page 19
Issue 5
UNIVERGE NEAX
®
2000 IPS
DML
The UNIVERGE NEAX IPS
DML
is equipped with all the features and functions of the UNIVERGE
NEAX 2000 IPS, with a smaller space requirement. It is a full-featured PBX that supports
advanced networking, pure peer-to-peer IP telephony connectivity and traditional TDM
switching capabilities. Designed primarily for pure converged IP networks, the UNIVERGE
NEAX
IPS
DML
can also accommodate a mixed (i.e., TDM and IP) converged IP network or
standalone solution.
The UNIVERGE
NEAX IPS
DML
(Internet Protocol Server Distributed Model) supports up to 952
peer-to-peer IP stations and 56 TDM ports in a single modular chassis. Up to eight chassis can be
stacked providing maximum capacity of 440 TDM ports while still supporting peer-to-peer IP
stations. It uses the same SPN-CP31E and the Main processor. The same line/trunk cards,
application processor cards and software of the UNIVERGE
NEAX
2000 IPS and comes equipped
for 19” rack mounting. It offers superior port density; each chassis only occupies two Rack Units
(2RU).
Characteristics of the UNIVERGE
NEAX IPS
DML
Compact and small size MODULAR CHASSIS
One MODULAR CHASSIS provides 8 card slots /56 LT ports and up to 8 MODULAR
CHASSIS can be used per system. (8 virtual LT ports are available per MODULAR CHASSIS in
addition to 56 LT ports.)
MP (Main Processor)
PN-CP31-E for UNIVERGE
NEAX IPS
DML
Ring Generator Unit (RGU)
Ring Generator Unit (RGU) for the UNIVERGE
NEAX IPS
DML
is provided with PZ-PW139 card.
The PZ-PW139 card provides ringing supply to analog SLT.
Power Failure Transfer (PFT)
Power Failure Transfer (PFT) for the UNIVERGE
NEAX
IPS
DML
is provided with PZ-4PFTA card.
The PZ-8PFTB for the UNIVERGE
NEAX 2000 IPS is not available for the IPS
DML
.
Installation Methods
The UNIVERGE
NEAX IPS
DML
can be installed on the desktop or into the 19-inch rack. Wall
Mount Installation is not available.