NEC UNIVERGE NEAX 2000 IPS - Isdn Features

CHAPTER 5 FEATURE DESCRIPTION
UNIVERGE NEAX 2000 IPS General Description Page 142
Issue 5
ISDN Features
Call-By-Call Service Selection
Services can be selected on a call-by-call basis to all channels of a single PRI interface according
to applications. Services may be used on any available channel, unlike Trunk Provisioning
Service, in which services are assigned to specific channels.
Called Party Recognition Service [Direct-In Termination (DIT)]
This feature provides an incoming Direct-In Termination (DIT) call via an ISDN trunk to be
connected to a predetermined station. This application can be used for a station or modem.
CLI Transparency
This feature provides a Calling Line Identity (CLI) received from ISDN or CCIS trunk to
transparently send outgoing ISDN trunk, in case of tandem connection (ISDN-to-ISDN or CCIS-
to-ISDN).
CPN to Network - Present
This feature allows the ISDN network to be informed of the Calling Party Number and Name
(CPN) when a call originates from a terminal connected to the System.
CPN to Terminating User - Display
This feature provides a visual display of the originating station’s number and sub-address
information on a Multiline Terminal for incoming ISDN calls. This provides the terminal user
with a quick and accurate way to identify the originating station’s number (Calling Number).
DID Addressing
This feature allows incoming ISDN-PRI calls to terminate to stations, attendant console,
automated attendant, etc., based on the called party number. Direct Inward Dial trunks will be
terminated to programmed destinations without attendant assistance.
DID Addressing and DOD Addressing
This feature allows the system to use DID and DOD on the same B-Channels. Trunk
Provisioning Service election is not required. (B-Channels can be used for DID and DOD
without separating the trunk routes.)
Event-Based CCIS
This feature allows a PBX customer who does not have a tie line (or when a customer cannot use
the tie line due to busy or fault of the line), to use the various CCIS feature by using the ISDN
line as a CCIS virtual tie line, on the IMX to UNIVERGE NEAX 2000 IPS connection or the
UNIVERGE NEAX 2000 IPS to IPS connection.
ISDN Terminal
This feature provides the system with an ISDN Terminal or Terminal Adapter (TA). ISDN
Terminal to ISDN Terminal, ISDN Terminal to ISDN Trunk, ISDN Trunk to ISDN Terminal,
ISDN Terminal to Single Line Telephone, ISDN Terminal to Multiline Terminal, and ISDN
Terminal to PS connections are available.
MEGACOM
®
Access/WATS
AT&T’s MEGACOM
®
(WATS) network, as well as WATS from other carriers, can be used.
MEGACOM
®
800 Service/800 WATS Ultra WATS
AT&T’s MEGACOM
®
800 (Inward WATS) network, as well as 800 WATS provided by other
carriers, can be used.