CHAPTER 5 FEATURE DESCRIPTION
UNIVERGE NEAX 2000 IPS General Description Page 143
Issue 5
MULTIQUEST
®
/900 Service
AT&T’s MultiQuest
®
service can be used. (It is a “900”-type service.) Also, 900 service
provided by other carriers can be used.
Sub-address – Present
This feature allows a Primary Rate Interface ISDN trunk to transfer the Called Party Sub-address
information to a destination ISDN station when the call is originated by the system. Dialing the
called party station number and sub-address is required.
Trunk Provisioning Service Selection
Each channel of a PRI interface can be dedicated to a particular service. Services are designated
to specific channels; once designated, a channel can be used only for that service.
Q-SIG Circuit Switched Basic Call – ETSI Version
Q-SIG conforms to ETS 300 172. This feature enables NEC’s PBX to connect to NEC’s PBX or
other manufacturer by using Layer 3 protocol for the signaling for the support of circuit mode
bearer services at the Q reference point.
The following services can be provided in conjunction with this feature:
a. Common station/voice service
Call Forwarding - All Calls Note 1
Call Forwarding - Busy Line Note 1
Call Forwarding - No Answer Note 1
Caller ID Display
Note 1
Direct-In Termination Note 1
Call Transfer - All Calls Note 1
Hot Line Note 1
Do Not Disturb
Note 1
Calling Number Display
b. Attendant Console service
System Speed Dialing Note 2
Call Queuing
c. Network features
Trunk-to-Trunk Connection
Brokerage - Hot Line
Least Cost Routing - 3/6 Digit
Tie Lines
Note 1: Service not based on the specification of Q-SIG supplementary service.
Note 2: Service provided with some limitations.
To Next Page
Loading...
