NEC UNIVERGE NEAX 2000 IPS - Application Processor (Ap) Cards

CHAPTER 4 EQUIPMENT DESCRIPTION
UNIVERGE NEAX 2000 IPS General Description Page 98
Issue 5
Application Processor (AP) Cards
The AP cards may be installed in slot 00 to 11 of PIM 0-7, with the following conditions:
• Maximum 24 cards per system
• Maximum 256 ports per system
Abbrev Name Code Ports Remarks
SPN-DTA (PRT)-A 25 1.5M Digital Trunk Interface
Used for either T1 or PRI. Used for T1 Interface -
24 channel T1 (Max 10 T1, using 24 APTS, Max
of 240 DTI Ports); Used for ISDN PRI Trunk
Interface with D-Channel Handler for 24 channel
ISDN Primary Rate (23B+D) included (uses 25
APTS). Lower/Upper AP Hwy.
RoHS compliant
DTI
SPN-30DTC-UA 30 2M Digital Trunk Interface
Uses 31 Application Time Slots. Max of 120 DTI
Ports w/this Interface. AP Number 4-15 & 20-31
Lower AP Hwy Applications; 2M AMI (30ch) T1,
CCIS (30B+C) requires SPN-SC00, CCH-D (AP)
for each CCIS Link.
PRT
SPN-DTA (PRT)-A 25 1.5M Digital Trunk Interface
Used for either T1 or PRI. Used for T1 Interface -
24 channel T1 (Max 10 T1, using 24 APTS, Max
of 240 DTI Ports); Used for ISDN PRI Trunk
Interface with D-Channel Handler for 24 channel
ISDN Primary Rate (23B+D) included (uses 25
APTS). Lower/Upper AP Hwy. RoHS compliant
CCT SPN-DTA (CCT)-B
25 Can be used as either 24 channel CCIS span or
Common Channel Handler for CCIS used with
T1. Card is a 24 channel CCIS Interface with C-
Channel Handler included. 1.5M Digital Trunk
Interface using 25 Application Time Slots. Max 8
CCIS Links. Lower/Upper AP Hwy. Used for
CCIS with Point to Point T1. RoHS compliant
BRT
SPN-4BRTA-H 8 4 circuit Basic Rate (2B+D) Interface Trunk Card
Accommodates 4 two-channel PCM digital lines.
Both Point-to-Point and Point-to-Multi Point are
supported. Lower/Upper AP Hwy. RoHS
compliant.
SIG SPN-DTA (QSIG)-A (AP) 25 QSIG combo card with Protocol Handler and
24DTAC. Supports the following Supplementary
Services (SS): SS-CLIP, SS-CLOP, SS-CLIR,
SS-CONP, SS-CNIR and SS-CONR.
Implementation of ID-SS (ETS 300 173) and
Name ID-SS (ETS 300 238) is based on basic
specifications of ETS 300 172 by ETSI at the Q
reference point between PBX’s
CFT
SPN-CFTC 32 32 Party Digital Conference
(Group Call/Meet Me)
• Group Call Automatic
• Group Call Broad Cast
• Group Call Two Way Calling