CHAPTER 3 TERMINALS
UNIVERGE NEAX 2000 IPS General Description Page 50
Issue 5
SN716 Desk Con
The SN716 Desk Console has an ergonomic design and provides full access to all PBX Console
features. It connects to the UNIVERGE
NEAX 2000 IPS using the same circuit cards as the Dterm
Series i/E terminals. The SN716 Desk Console operates on a switched-loop basis with a
maximum of 6 Attendant loops terminating at each console on the associated Interface card. The
Attendant uses these loops for answering, originating, holding, extending, and reentering calls.
When Attendant loop release is used, the number of loops is effectively increased to a maximum
of 12 for each console. The SN716 Desk Console also provides flexible key assignments to meet
the operator's needs. Key assignments are semi-fixed by system default data, but may be
changed via programming.
The UNIVERGE
NEAX
2000 IPS supports a maximum of eight SN716 DESK Consoles.
SN716 DESKCON Features
• Character LCD (4x40 characters)
• LCD designation strips
• Software-controlled LCD loop key
• Full access to PBX features
• Headset connectivity
• Recorder connectivity
Dimensions: 10 inches (25.4 cm wide x 9 inches (22.9 cm) deep x 4 inches (10.2 cm) high
Line Conditions of the SN716 DESKCON
The cable length between the DLC card and terminal varies depending on the type of terminal.
The table shows the line conditions of the Attendant Console.
Line Conditions of the SN716 DESKCON
Interface Cards Type Power Options Cable Length* (Cable 0.5/24 AWG)
PN-PW00
PN-8DLCL/8DLCP
AC Adapter
1000 ft. (304 m)
PN-PW00 1000 ft. (304 m)
PN-4DLCM/4DLCQ
AC Adapter 4000 ft. (1200 m)
*Cable length is based on the diameter of the cable and the terminal impedance.
To Next Page
Loading...
