CHAPTER 5 FEATURE DESCRIPTION
UNIVERGE NEAX 2000 IPS General Description Page 113
Issue 5
Customer Administration Terminal (CAT)
In addition to the Maintenance Administration Terminal (MAT), programming of the
UNIVERGE NEAX 2000 IPS can be done from selected Multiline Terminals with LCD. The
designated Multiline Terminals can be placed in program mode, and system data can then be
changed. To prevent unauthorized changes, password levels are assigned, providing
authorization for access to certain areas of programming and denying access to others.
Data Line Security
This feature allows line circuits that are used for data transmission to be protected from
interruptions such as Attendant Camp-On, Executive Override, and Attendant Override.
Delayed Hotline
When a station user goes off-hook and waits for a certain period of time without dialing
operation, the station user is automatically routed to a specified Hotline station or an attendant. If
the station user dials a number before the preprogrammed time, the station user can make a call
as usual.
Delayed Ringing
This feature enables trunks and station lines to ring immediately at the terminating station, but
also, after a programmable period of time has elapsed, to ring at secondary Multiline Terminals
with that trunk or line appearance.
Diagnostics
To assist maintenance personnel, the UNIVERGE
NEAX
2000 IPS provides diagnostic
capabilities such as fault code generation, device status information and alarm information
recording which can be accessed from the Maintenance Administration Terminal (MAT) or
Customer Administration Terminal (CAT).
Dial by Name
This feature allows a Multiline Terminal user to search for a desired number by name. The
number and name are registered in the system and they are shown on Multiline Terminal LCD.
The Multiline Terminal user can search for the desired number by name using up or down soft
keys. When the Multiline Terminal user finds the desired number, the call can be originated by
pressing the Line/Trunk key or going off hook.
Dial Conversion
The system can be assigned to use rotary Dial Pulse (DP) or Dual Tone Multi-frequency
(DTMF) trunks and stations. This feature provides for the repeating of digits dialed by the station
user onto the C.O. trunks.
Direct Data Entry
This feature allows a maid or other hotel personnel to enter numeric data to the Property
Management System (PMS), using the guest room station for entry through dial operation. The
same numerical data can be output to a Hotel/Motel Printer by system data programming.
Direct Digital Interface
This service feature provides the capability to connect trunks from the UNIVERGE NEAX 2000
IPS directly to T1 carrier links using either a private or public network.
To Next Page
Loading...
