NEC UNIVERGE NEAX 2000 IPS - Page 176

CHAPTER 7 SPECIFICATIONS
UNIVERGE NEAX 2000 IPS General Description Page 172
Issue 5
IPS
DML
System Capacity
System Capacity Note 1
Item
1 MC 2 MC 3 MC 4 MC 5 MC 6 MC 7 MC 8 MC
Physical Module Chassis
1 2 3 4 5 6 7 8
Physical MC Port for Line/Trunk
48 104 160 216 272 328 384 440
Built in FP (on MP)
1
FP card (PN-CP33) 0 1 2 3
IP PAD (No. of Channel)
Note 2 32 64 128 192 256
Standard 48 104 160 216 272 328 384 440 Analog Single Line Telephone
(Lines)
Long 12 24 36 48 60 72 84 96
Standard 48 104 160 216 272 328 384 440
Dterm (Lines)
Long 8 16 24 32 40 48 56 64
DSS/BLF Console 8 16 24 32
DtermIP/ INASET / SP30 (Peer to Peer Connection) 956 892 828 764 700 636 572 508
Dterm PS 512
Zone Transceiver (ZT)
16 32 48 64 80 96 112 128
P-P Connection
12 26 32
ISDN Terminal (2ILCC)
P-MP Connection
24 52 64
Loop Start
48 104 160 216 256
Central Office Trunk (Lines)
DID w/4DIT 24 52 80 108 136 164 192 220
2W or 4W E&M 24 52 80 108 136 164 192 220
Tie Line Trunk (Lines)
Type 1 w/PW122 4 8 12 16 20 24 28 32
CCIS Trunk (Peer to Peer Connection) Max. 127
DTI/CCIS Digital Link
Note 3
1.5M DTI: 10, CCIS: 8
1.5 (PRT) 8 Main, 32 Total
ISDN
4BRT (card) 5 10 15 20 24
IP Trunk (IPT card or H.323 card) 1 2 3 4 5 6 7 8
PFT Connections 4PFTA 4 8 12 16 20 24 28 32
3-Party Conference Max. 16 conference groups per system
8-Party Conference Group Max. 8 conference group per system
32-Party Conference Group Max. 8 conference group per system
DTMF Sender Max. 32 circuits per system
DTMF Receiver 16 32
SN716 Desk Console 8
Attendant Terminal (Dterm ATT Position) Max. 8 sets per system
Note 1: "MC" in this table means "Physical Module Chassis."
Note 2: Number of IP PAD card is maximum 2 per FP.
Note 3: The total number of trunk line and DTI channel shall be 256 or less. (Each trunk line and DTI
channel are required to assign the “Trunk Number” by system data programming and maximum
number of system parameter for “Trunk Number” is 256.)