ACD Installation Manual 4 - 1
Programming
4Programming
SECTION 1 BEFORE YOU START PROGRAMMING
This chapter provides detailed information about the system programs. By
changing a program, you change the way the feature associated with that
program works. In this chapter, you find out about each program, the
features that the program affects and how to enter the program data into
system memory.
SECTION 2 HOW TO USE THIS CHAPTER
This chapter lists each program in numerical order. For example, Program
10-01 is at the beginning of the section and Program 92-01 is at the end.
The information on each program is subdivided into the following
headings:
Description describes what the program options control. The Default
Settings for each program are also included. When you first install the
system, it uses the Default Setting for all programs. Along with the
Description are the Conditions which describe any limits or special
considerations that may apply to the program.
The reverse type (white on black) just beneath the Description heading is
the program access level. You can only use the program if your access
level meets or exceeds the level the program requires. Refer to Section 4
How to Enter and Exit Programming Mode on page 4-3 for a list of the
system access levels and passwords.
Feature Cross Reference provides you with a table of all the features
affected by the program. You may want to keep the referenced features in
mind when you change a program. Customizing a feature may have an
effect on another feature that you did not intend.
Do not start customizing your system before reading
Chapter Setting Up ACD for the First Time on page 2-1.
To Next Page
Loading...
