Issue 4.0 UNIVERGE SV8100
4 - 6
SECTION 6 PROGRAMMING NAMES AND TEXT MESSAGES
Several programs (e.g., Program 20-16: Selectable Display Messages) require you to
enter text. Use the following chart when entering and editing text. When using the
keypad digits, press the key once for the first character, twice for the second
character, etc. For example, to enter a C, press the “2” key three times. Press the key
six times to display the lower case letter.
Use this keypad
digit . . .
When you want to. . .
1
Enter characters:
1 @ [ ¥ ] ^ _ ‘ { | }
Press repeatedly to scroll through the list. After selecting your entry, press the next letter or use the left
scroll or right scroll Softkey to move the cursor.
2
Enter characters: A~C, a~c, 2. After selecting your entry, press the next letter or use the left scroll or
right scroll Softkey to move the cursor.
3
Enter characters: D~F, d~f, 3. After selecting your entry, press the next letter or use the left scroll or
right scroll Softkey to move the cursor.
4
Enter characters: G~I, g~i, 4. After selecting your entry, press the next letter or use the left scroll or
right scroll Softkey to move the cursor.
5
Enter characters: J~L, j~l, 5. After selecting your entry, press the next letter or use the left scroll or right
scroll Softkey to move the cursor.
6
Enter characters: M~O, m~o, 6. After selecting your entry, press the next letter or use the left scroll or
right scroll Softkey to move the cursor.
7
Enter characters: P~S, p~s, 7. After selecting your entry, press the next letter or use the left scroll or
right scroll Softkey to move the cursor.
8
Enter characters: T~V, t~v, 8. After selecting your entry, press the next letter or use the left scroll or
right scroll Softkey to move the cursor.
9
Enter characters: W~Z, w~z, 9. After selecting your entry, press the next letter or use the left scroll or
right scroll Softkey to move the cursor.
0
Enter characters:
0 ! “ # $ % & ‘ ( )
Press repeatedly to scroll through the list. After selecting your entry, press the next letter or use the left
scroll or right scroll Softkey to move the cursor.
Enter characters:
+ , - . / : ; < = > ?
Press repeatedly to scroll through the list. After selecting your entry, press the next letter or use the left
scroll or right scroll Softkey to move the cursor.
Softkey Left/
Right Arrows
Accepts an entry (only required if two letters on the same key are needed - ex: TOM) and moves
cursor in the arrows direction.
CONF Clear the character entry one character at a time.
CLEAR Clear all the entries from the point of the flashing cursor and to the right.
To Next Page
Loading...
