Chapter 1 MAINTENANCE SERVICES
1-53 NWA-033627-001 Rev.4.0
95ch1001.fm
PING COMMAND
(4) You can not execute the ping command from multiple PCPro/CAT terminals at once. If you do that,
“WAIT, BUSY NOW” is displayed.
(5) Even if a LAN port on the CPU blade is being used for PCPro/OAI or any other terminals, you can
execute the ping command.
(6) The following key operations are effective when the reply message resulting by executing the ping
command is displayed.
• DE (space key): To send again a ping request to the same IP address as the last one.
• - (hyphen key) : To send a ping request to the IP address with 1 subtracted from the last one.
Example: The ping request is sent to “192.168.1.2” if you press DE (space key) after sending it
to “192.168.1.3”.
• S (return key) : To send a ping request to the IP address with 1 added to the last one.
Example: The ping request is sent to “192.168.1.3” if you press S (return key) after sending it to
“192.168.1.2”.
NOTE: A LAN port on the CPU blade becomes occupied if you execute a ping command while DE
(space key) is pressed.
(7) When LAN feature is not available due to a system data is not assigned or other reason,
“HARDWARE ERROR” is displayed.
(8) The reply message resulting by executing the ping command is directly displayed in ICMP TYPE.
And “OK”/ “ERROR” displayed in PCPro is not displayed. The reply message is as follows.
Example 1 <The reply message resulting by executing the ping command>:
COMMAND=FA2001
FA2001>192.168.1.2
192.168.1.2: 0 ping OK (ICMP TYPE=0 Reply)
Example 2 <The reply message resulting by executing the ping command>:
COMMAND=FA2001
FA2001>192.168.1.2
192.168.1.2: 3 ping NG (ICMP TYPE=3 Host unreachable)
JULY/17/2009
To Next Page
Loading...
