UT880 Owner’s Guide 2 - 1
Basics
2Basics
SECTION 1 CONNECTIONS
Before installing UT880, the safety items specified in the beginning of this
manual should be carefully read and understood. Then, a proper
installation place shall be selected.
1. Connect the Ethernet cable to the LAN port. (When a UT880 is to be
used with a PC, the PC’s Ethernet cable should be connected to the
LAN connection port while the PC is connected to the handset’s PC
connection port.). The LAN and PC connector is a RJ-45 type, and
the Ethernet cable is a UTP cable (Category 5).
2. Connect the ends of the Ethernet cable to the PC and the UT880 PC
Ethernet port.
3. The UT880 is a PoE enabled device, so no power adapter is needed.
When the UT880 has completed booting it will get an IP address from a
DHCP server.
The UT880 factory default is set to use DHCP, so if there is a designated
DHCP server on the user’s network, the IP address will be automatically
assigned. However, if there is no DHCP, an available static IP should be
requested and assigned by a network administrator.
1.1 Get the Phone IP Address
The UT880 requires an IP address assigned for the corresponding
network environment. Factory default is enabled for DHCP
(Dynamic Host Configuration Protocol).
Dynamic IP
Static IP
A Static IP Address is a fixed intra-net or Internet address that is
assigned to a specific user by a network administrator.
To Next Page
Loading...
