Necta Canto Plus Espresso - Mixer and Water Dose Settings; Mixer Operation Settings; Water Dose Parameters; Brewing Time and Powder Doses

© by N&W GLOBAL VENDING S.p.A. 31 10 2009 3325 - 00
mixer
mixing mode
For every single selection you can set the duration of the
mixing cycle for every single water dose composing the
selection.
The duration can be set in two dierent modes:
absolute
i.e. not depending upon the start time of the pump.
The duration of the mixing cycle is set in tenths of a
second and it is calculated from the time the pump is
started up
relative
i.e. by way of dierence, either in excess or in default,
compared to the stop time of the pump.
E.g.: if the value is 0, mixing will stop as soon as the
pump stops.
The duration of the mixing cycle is always expressed in
tenths of a second.
mixing speed (low / medium / high)
You can dene the mixing speed according to the prod-
uct quality you wish.
mixing Time
You can dene how long the mixer shall be active after
the pump stop within one single product.
Brewing parameTers (fB only)
Parameters not available
waTer doses
To dispense water, act on the following parameters:
evenT sTarT (0 - 3)
Set this value to dispense the water of the relative ingre-
dient after the water with the lowest value.
In doing so, you can vary the sequence of the various
ingredients to get the best product quality.
delay value
You can set up the mixer delay (in hundredths of a sec-
ond) with respect to the pump start (event start)
dose in cc
You can directly set up the water quantity you wish for
every single event start in cc.
dose in cdv (for espresso drinks only)
You can directly set up the water quantity you wish
for the event start relative to an espresso drink in cdv
(strokes).
flow raTe in cc/sec.
You can set up the working speed of instant water
pumps to dene the ow rate in cc/sec.
This value is used to calculate the time necessary to
dispense the dose in cc.
Brewing Time
You can set the brewing time just for the selection of
reference of automatic grinding.
powder doses
To dispense powders, act on the following parameters:
dose in grams
You can directly set up the powder quantity you wish for
every single ingredient composing the drink in grams.
flow raTe in gr/sec.
You can set up the working speed of ingredient motors to
dene the ow rate in gr/sec.
This value is used to calculate the time necessary to
dispense the dose in gr.
decaff cycle or sTep dispensing
Use this function to establish for every single instant
coee selection whether powder shall be dispensed ac-
cording to a deca cycle or on a step basis, compared to
“global” setting.
- DECAFF CYCLE: use this parameter to dispense
powder before water to improve the drink quality (recom-
mended for instant coee).
- STEP: use this parameter to dispense powder at inter-
vals (you can set up from 1 to 5) at the same time as
water.