Necta Canto Plus Espresso - Display and Espresso Unit Settings; Display Language and Promos; Screen Saver and Contrast Settings; Menu Access and Password

© by N&W GLOBAL VENDING S.p.A. 34 10 2009 3325 - 00
display
This group of functions controls all display parameters.
language
Use this function to select the language you wish to use
to display the messages among those made available by
the software.
secondary language
To select a second language to display the messages in
the “normal operation mode”.
seTTing up The promoTional message
The 5-line message can be composed by using the keys

and

to scroll all available characters.
If you press the Enter key

, the rst character you can
modify will ash on and o.
Press the key

to store the message.
promoTional image
To enable/disable the promotional image on the display
in the normal operation mode:
- ON: the message “Select a product” and the promotion-
al image are alternated every 3 seconds in the normal
operation mode
- OFF: only the message “Select a product” is displayed
in the normal operation mode.
saver screen Time
Use this function to set the screen saver after a program-
mable (in minutes) shutdown time of the vending ma-
chine (default = 10 min.)
Set the value to 0 to deactivate the screen-saver.
lcd conTrasT regulaTion
Use this function to regulate the display contrast from
min. 5% to max. 99% (default).
menu managemenT
password
It is a 5-digit numeric code you are required to enter to
display all menu functions (advanced).
The value of this code is set to 00000 by default.
reduced / compleTe menu enaBle
To enable the request for password function in order to
display all “advanced” functions of the Technician Menu
as soon as you access the programming mode. The
request for password is disabled by default.
espresso uniT
pre-grinding
Use this function to enable or disable the grinding cycle
of a coee dose for the next selection.
This will enable the user to reduce the time required to
dispense a coee selection. The function is disabled by
default.
waTer BoosT
Enable this function to heat the water circuit and the
espresso unit before brewing espresso coee.
If no espresso coee based selection is performed for a
long time, a small hot water quantity is dispensed before
releasing a coee dose.
espresso uniT posiTion
Function active on double espresso models only.
Use this function to set up the position of the unit while
dispensing the ground coee dose. Regulation occurs
through scrolling keys

and

fresh Brew uniT (if The fB uniT is availaBle)
You can set up the parameters relative to the fresh brew
unit (if available) in this group of functions.
pre-Brewing Time
Use this function to establish the pause time of the brew-
ing unit in tenths of a second before brewing (default 100
d/sec.).
drying Time
Use this function to establish the pause time of the brew-
ing unit in tenths of a second after brewing and before
ejecting the used dose (default 100 d/sec.).
exTracTion pressure
Use this function to regulate the piston speed and the
pressure exerted on the dose in the brewing chamber
(default 5).
Act on this parameter to modify the drink aspect
and quality.
profile managemenT
Use this function to choose among the 5 proles avail-
able for selections based on fresh brew coee or tea.
For coee:
- Standard Profile
- Low Pressure
- High Pressure
For tea:
- Standard Profile
- High Pressure