Necta Canto Plus Espresso - Machine Configuration Options; Date and Time Setting; Boiler Temperature Configuration; Database Management

© by N&W GLOBAL VENDING S.p.A. 33 10 2009 3325 - 00
MACHINE CONFIGURATION
This group of functions is intended to check all param-
eters relative to the operation of the machine.
MACHINE CONFIGURATION
SET DATE TIME
BOILER TEMPERATURE
DB MANAGEMENT
DISPLAY
MENU MANAGEMENT
ESPRESSO UNIT
FRESH-BREW UNIT
WASHING SECTION
TECHNICIAN> X.X
daTe and Time seT
Function used to set up the current date and time. The
value is used to manage the time band and statistics.
Boiler TemperaTure
Use this function to set the operating temperature,
expressed in °C, of the boilers actually available on the
machine.
If you press the Enter key

after having selected the
boiler where to act, the temperature value will ash on
and o and it can be modied.
dB managemenT
This group of functions is intended to manage the basic
data of the machine operation.
iniTialisaTion
This function shall be used in case of a memory data
error or if the software is replaced.
All statistic data are reset except for the general elec-
tronic counter.
When the display is set to the “Initialisation” function, you
can initialise the machine by restoring all default data.
Press the Enter key

to display the request for con-
rmation “Do you conrm?”. If you press the Enter key

once again, you will be required to enter some
parameters, i.e:
“counTry”
understood as the type of basic doses for the various
selections (e.g. IT coee = 60 cc - FR coee = 106 cc).
The “countries” made available according to models.
“lay ouT”
a well-dened number of Button-Selection combinations
is available for selection for every single model and type
of doses (the combinations available for every single
layout are supplied by the selection dose table supplied
with the machine).
“Tank”
Used to dene whether water supply occurs:
0 - from the network
1 - with an internal tank
2 - with two internal tanks on management.
Conrm the options to display the message “Execution”
for some seconds.
save cusTom dB
To save the current conguration of the machine on an
external memory. This function is of use if you customise
(e.g. the parameters of selections) with respect to factory
settings.
resTore cusTom dB
To restore the machine conguration you have custom-
ised and saved before by means of the “Save modied
DB” function.
To restore factory settings, initialise the machine.