Necta Canto Plus Espresso - Energy Saving and Master;Slave Configuration; Energy Saving Mode Options; Master;Slave Setup; Slave Machine Monitoring

© by N&W GLOBAL VENDING S.p.A. 36 10 2009 3325 - 00
energy saving
Choose among the following energy saving options to
save electric energy whenever the machine is not used:
Energy Saving:
use this option to interrupt the vending machine service
and power o the boiler/s at the time intervals set up by
the “Energy Saving Parameters” function.
Selections are not available for the whole duration for the
Energy Saving period.
Sleep Energy Saving:
use this option to power o the lighting LEDs of the front
panel after a 15-minute inactivity of the vending machine
and to lower down the boiler temperature to 70°C. Press
any selection button to restore the normal operation of
the machine. Selections are made available once again
as soon as you reach the operating temperature.
Soft Energy Saving:
use this option to power o the lighting LEDs of the front
panel at the time intervals set up by the “Energy Saving
Parameters” function whereas the boiler/s will continue
to operate normally. Press any selection button to turn
on the LEDs and to restore the normal operation of the
machine.
energy saving parameTers
Use this function to set up to 4 time bands in which to
activate energy saving proles (Energy Saving and Soft
Energy Saving).
ouT of service panel BacklighTing
You can dene whether to turn on or not the LEDs
intended to light the panels when the machine is out of
order or the “Service interruption” range has tripped.
cold uniT id seTup
Function active if the cold unit is available.
masTer slave
The control system of the machine is arranged for bank
connection with other automatic vending machines
(Samba, Samba Top and Diesis)
seTup
Use this function to set up the hierarchies of the master
/ slave1 / slave2 relations between connected vending
machines.
This machine can be congured as “Master”, i.e. control-
ling the second machine, or as “Slave”, i.e. controlled by
the other one.
Moreover, set the two-digit (XX) or three-digit (0XX; 9XX)
numbering of selections.
The master/slave function is not enabled by default.
slave price holding (execuTive proT.)
If the Executive payment system is set in the “Price Hold-
ing” mode, use this function to set the same mode in the
slave machine software too.
virTual price reTurn (exe / Bdv proT.)
If selections are either combined or virtual (the menus of
which are available on slave machines), use this function
to establish whether to withhold (OFF) or not (ON) the
partial amount if the second selection / delivery should
fail.
minislave reseT
Use this function to reset all settings relative to the mas-
ter/slave function on the slave machine.
moniTor slave
Use this function to scroll all the information relative to a
slave that may be connected.
If you power on the slave machine after having displayed
this function, the following slave information will appear
in sequence:
- software release
- type of slave (XX, 0XX, 9XX)
- presence of photocells intended to detect dispensing
- number of trays and drawers
- presence of a device intended to lock the opening of
the dispensing compartment
- temperature measured by the internal probe.
To quit the function, power o the master machine.
slave informaTion display
Function not active on this model.
Use this function to display the instantaneous tempera-
ture of the “slave” machine you may have connected.