© by N&W GLOBAL VENDING S.p.A. 37 10 2009 3325 - 00
machine serial numBer
Use this function to change the eight-digit numeric code
intended to identify the vending machine (default set to
0).
programming The operaTor code
When the display is set to the “Operator Code” function,
you can change the 6-digit numeric code identifying
groups of machines (default to 0).
locaTion code
When the display is set to the “Location Code” function,
you can change the 8-digit numeric code identifying the
place of installation of the machine (default to 0).
insTallaTion daTe
Use this function to store the current system date as the
installation date.
The date is printed at the time of rolling out statistics.
programming The machine code
When the display is set to the “Machine Code” function,
you can change the 8-digit numeric code identifying the
machine (default to 0).
aspiraTor managemenT
Use this function to set the continuous operation of the
suction fan wheel of instant products:
- ON fan wheel always on;
- OFF fan wheel on only during the dispensing cycle and
for the next 30 seconds.
TEST
TEST
TEST DISPENSING
SPECIAL FUNCTIONS
AUTOTEST
TECHNICIAN> X.X
TesT dispensing
Function used to dispense the following for every single
selection when the door is open and without inserting
the amount required:
- complete selection
- water only
- powder only
- no accessories (cup, sugar and stirrer)
- accessories only
special funcTions
If you access the function, you can:
- operate the brewing unit (if available)
- release a coffee dose (if available)
- open a solenoid valve to let air in if the boiler is emptied
for maintenance purposes (ES only)
- install the boiler manually
- operate the mechanism intended to dispense a stirrer:
press key
and
to release the stirrers from the 2
(front and back) columns
- operate fresh brew 1 and 2 brewing units (if available)
- regulate grinding wheels (models, the grinding wheels
of which are automatically regulated)
To Next Page
Loading...
