Nedap ANPR LUMO - Software Update and Serial Setup

ANPR LUMO | installation guide
42/45
version 4.3.1 cannot import configurations other than 4.3.1
version 4.3.2 can import configurations of version 4.3.0 and 4.3.1.
CHANGE SYSTEM PASSWORD Changing the system password. We recommend to change the system password.
Important note:
Make sure you store this password in a secure place. The system password cannot
be recovered. In case you lose the system password, the camera must to be
returned to Nedap.
CHANGE LANGUAGE Select user interface language.
UPDATE SOFTWARE Update the ANPR Lumo software, at the file selection select the ZIP file
SETUP SERIAL * Setup RS485 serial parameters.
Select to use BASIC or OSDP communication protocol.
Select the baud rate.
When using OSDP communication, you may also select the OSDP device address
and the OSDP secure channel base key (OSDP-SCBK). The OSDP key must be
exactly 16 bytes, e.g. 303132333435363738393a3b3c3d3e3f.
* requires at least ANPR LUMO hardware revision A.05 and software v4.5.1.
SETUP SSL Configure the ANPR Lumo web-interface to use SSL. If you do not upload your own
certificate, a self-signed certificate is used.
TERMINAL TOOLS With terminal tools you can run some simple network diagnostics, like ping,
Traceroute and IP.
FACTORY RESET This option is used to reset the camera configuration back to factory settings.
All custom configuration data will be lost!