ANPR LUMO | installation guide
2 Getting started
2.1 Mounting the ANPR LUMO
Determine how to mount the ANPR. The ANPR LUMO can be installed onto a pole or behind the barrier. Mount behind
the barrier to ensure recognition right in front of the barrier.
Important mounting issues are:
Best focus distance is between 2 and 10 meters [7 … 26 ft].
Angle between ANPR and number plate should be smaller than 25 degrees.
Mounting details are described in chapter 3.2.
2.2 Connecting the ANPR
The ANPR is delivered with 5m cables for power, I/O and network. Power supply, RS485 communication and I/O are
combined in one cable. Ethernet network is a separate cable. The cables are pre-fitted to the ANPR. For installation the
ANPR does not need to be opened. Connecting the power supply and network cable are required to configure the
ANPR.
2.3 Assigning an IP-address
Enter the default IP-address in the address bar of your web browser.
Default IP address is:
IP address: 192.168.3.15
The login window appears where the user is asked to type the username and password.
Username: admin
Password: secret
Go to the system configuration and setup the network configuration as desired. If required, now also other
configuration settings may be changed.
Note : The ANPR LUMO software interface is not compatible with Internet explorer
2.4 Testing the ANPR
Test the ANPR to check if it is aligned correctly and if it is able to read the license plates. Drive the vehicle into the
position where it should be possible to read its license plate.
Connect to the ANPR using your web browser on the main page you can see the live video. On the right side of the page
the text results are shown. It might be necessary to adjust the ANPR alignment.
To Next Page
Loading...
Need help?
General