Nederman HV Control Panel EX Series - Page 29

HV Control Panel
29
EN
Pilotinterlock:NoushingduringacvePilotsignal.Flushingsequenceisiniatedwhen
Pilotsignalisdeacvated,butshouldwaitunlaPilotinterlockedcleaningandAEB
sequenceisperformed.
DIRandSSRmeshallbesetlongenoughtoallowproperushing.
Atshutdownensurethattheductsystemispurged.Byselecng“Flushatstop”=Yes,
theushsequenceisexecutedbeforenormalstops.ForanE-stoporastopbecauseofan
alarm,theushingisomied.
TheushingisexecutedattheendofSSRme,orwhenthesystemgoesfromStandby
toO,controlledbytheStopbuon,RemotecontrolorWeekmer/overme.ForRBUin
idlingmode,ithastoenternon-idlingduringtheFlushingsequence.
6.6.9 Sengs - Weekmer
Enable Weekmer
Anadministratorpasswordisrequiredtochangeseng.
PressYestoenabletheWeekmerfuncon.TheWeekmersetsthemodefromOFFto
Standbyaccordingtothesetstart/stopme.
OvermeandMondayareontherstpage.Sundayisonthelastpage.
TheWeekmerhasfourperiodsperday,ifsetsolely00.00-00.00,thereisnoacve
period.
WEEKTIMER Range Default Used
EnableWeekmer Yes/No No