N1500i FACS Manual
43
Part No. 729-110-053 V.1.03 © 2018 Nelson Stud Welding, Inc. All rights reserved.
Use:
The unit is now locked and ready to weld. When a weld is out of tolerance, the
unit will flash the red triangle icon and display 'WELD ERROR - ENTER
PASSWORD'.
Enter the password to resume welding. Once the password is entered, the
triangle will still be flashing, but the user can resume welding.
If any weld settings are to be changed or F code configurations are to be
accessed, the unit must be unlocked before doing so.
To Next Page
Loading...
