Nelson N800i - E018 Warning - Drop Time Is too Long for Short Cycle

N1500i FACS Manual
81
Part No. 729-110-053 V.1.03 © 2018 Nelson Stud Welding, Inc. All rights reserved.
8.3.16 E018 Warning - Drop Time is too long
for Short Cycle
Fatal, meaning you have to power down to continue welding
>> No
Acknowledge, meaning the error will exist as long as the unit
is powered on. (Note, welding can continue while the error
exists)
>> No
Description: The Configuration of the drop time (F31) and the front panel
time make it such that the pilot arc supply must be on for more than
40ms. The Maximum time the pilot arc will stay on is 40ms, so it is
possible the arc will go out before the main arc starts. For consistent
welds, reconfigure the drop time and\or front panel time to satisfy the
equation.
E018