Tucker GmbH, Mail / Post: Max-Eyth-Str.1, 35394 Gießen, Germany
Stud welding unit N800i
As of 24.08.2021
Manual part number: BE 1227
2. Safety at work
2.1 Safety Symbols
Safety notices and warnings are made on the one hand for your personal safety and
on the other hand for product safety. In these operating
instructions they are made
to stand out by means of the following safety symbol.
The applied symbol has the following meaning:
The caution sign draws your attention to potentially dangerous
situations. It is always used in connection with one of the
supplementary terms which are defined as follows.
The used supplementary terms have the following meaning:
Warning!
The system operator is obliged only to allow persons to work with the
unit,
who are acquainted with the safety at work and accident prevention
regulations and have a training authorizing them to perform stud welding!
All persons who work with the unit are obliged to read and
observe all the
operating and service instructions of the welding unit
prior to
commencing work! In addition, the operating instructions of
the weld gun
connected in each case must be read and observed!
The addendum means that death, grievous bodily harm or
considerable damage to property will occur if the
corresponding preventive
measures are not taken.
The addendum means that death, grievous bodily harm or
considerable damage to property can occur if the
corresponding preventive
measures are not taken.
The addendum means that slight bodily harm or damage to
property
can occur if the corresponding preventive measures
are not taken.
This sign contains important information about the correct
method of
handling the product or special advice, to which
particular reference
is to be made.
To Next Page
Loading...
