3. Delivery and Transport
3.1 Extent of delivery
Included in the extent of delivery of the Nelweld N800i welding unit
are the following
unit components and accessories:
• 1 Nelweld N800i welding unit
• 1 set of operating and service instructions for the Nelweld
N800i
3.2 Packing and dispatch
Unless otherwise agreed, the type of packing complies with HPE regulations, which
were laid down by the Federal Association for Wooden
Materials, Pallets and Export
Packing.
3.3 Inspection of incoming materials
The operability of the welding unit was tested prior to dispatch.
On arrival the welding unit has to be checked for damage as well as for
the
completeness of the parts within the extent of delivery.
Any possible transport damage and/or missing parts have to be immediately made
known to the manufacturer or the authorized forwarding
company.
3.4 Intermediate range
If the Nelson N800i welding unit is not operated immediately after
delivery, it must
be put into intermediate storage in a secure place.
The welding unit must be sufficiently protected against dust and moisture.
The storage temperature may be gathered from the Technical Specifications.
3.5 Storage
If the welding unit is not operated immediately after delivery, it must
be put into
intermediate storage in a secure place. To this end the Nel-
weld N800i has to be
sufficiently protected against impurity and
moisture.
3.6 Transport
In order to avoid damage to the welding unit, the N800i may only be
transported by
the foreseen handles or by means of suitable lifting gear.
To Next Page
Loading...
