Tucker GmbH, Mail / Post: Max-Eyth-Str.1, 35394 Gießen, Germany
Stud welding unit N800i
As of 24.08.2021
Manual part number: BE 1227
The mains cable may not be misused as a handle.
3.7 Operating Location
The operating location of the N800i welding unit is restricted to areas of industrial
and trading nature. Welding can cause radio interference in residential and
commercial areas.
• Welds that are performed at temperatures below 5°C may have a negative
influence upon the welding result.
• To protect people not involved, the operating location must be amply cordoned off
and clearly marked with warning and informatory signs.
• Inflammable and explosive materials must be removed from the danger zone.
We expressly point out that welding in commercial areas, in the open
or in open halls is as a general principle forbidden.
Danger!
• Wearers of cardiac pacemakers are as a general principle forbid-
den to stay in the vicinity of stud welding facilities.
• Electrical external appliances can be disturbed or damaged by the
electromagnetic fields, which occur when welding. Therefore, a
minimum clearance of 10m has to be guaranteed between the wel-
ding apparatus and the external appliances.
• It is forbidden to operate the equipment in an environment where
there is a risk of fire, explosion or dampness beyond the power
units IP rating.
To Next Page
Loading...
