2.3 Intended use
During the design and manufacture of the Nelweld N800i the relevant guidelines and
standards were observed. The welding head was built according to state of the art
technology and is operationally reliable.
Nevertheless, dangers can originate from the Nelweld N800i welding head if it is
operated by untrained people or is not used as intended.
Observation of the following points falls under intended use:
• The N800i is designed for welding studs according to the drawn‐arc and the short‐
cycle welding methods.
• The specifications in these operating instructions with regard to material
combinations and the particularities of studs and ceramic ferrules have to be
observed.
• The Nelweld N800i is not suited for use in residential and business areas
because electromagnetic disturbance must be expected in external electrical
equipment as a condition of its process.
• The operating location of the Nelweld N800i is limited to areas of an industrial and
trading nature. When used in residential and commercial areas the user of the
system must ensure that the electromagnetic fields that occur during welding do
not cause any dangers to persons and property.
• The Nelweld N800i is only permitted to be used with the cited accessories.
Alterations to the Nelweld N800i not authorised by the manufacturer are
forbidden.
• The Nelweld N800i is only to be operated with the plant compo nents listed in. It is
not permitted to configure the equipment with that of other manufacturers.
• Furthermore, the observance of the general and particular safety advice in these
operating and service instructions as well as relevant accident prevention
regulations (BGV D1
1
; BGR 500
2
) falls under indented use.
Operation in accordance with regulations also includes observing the general and
special safety instructions contained in this documentation as well as the local
regulations on accident prevention.
To Next Page
Loading...
