Tucker GmbH, Mail / Post: Max-Eyth-Str.1, 35394 Gießen, Germany
Stud welding unit N800i
As of 24.08.2021
Manual part number: BE 1227
Warning!
In keeping with standard EN 60974-10 the welding unit N800i is
suited for use in an industrial environment (limit class A).
We expressly point out that units of limit class A can cause radio
interference in residential and commercial areas!
Safety measures prior to commencing work:
Each time, prior to commencing work (shift change), check:
• the welding unit for perceptible outer damage
• The correct application of all protective devices
• all connecting cables for mechanical damage
• The measures required to reduce emitted interference
• for a secure fit of the supply tube system on the screwed in connection
Warning!
During welding certain exposed parts of the weld gun such as the
stud and the chuck and all parts electrically connected with this are
current carrying.
Wear no electrically conductive jewelry such as rings, watches or
chains!
Safety measures during normal operation:
• Only use the welding unit when in a technically perfect condition
• Refrain from any manner of working, which is hazardous to
safety
Safety measures after work completion:
• Switch the welding unit off and disconnect the main plugs
• Secure and label the welding unit against unauthorized use
• Ensure that the stipulated maintenance intervals are observed
Safety measures in case of malfunctions:
• Switch the welding unit off and disconnect the main plugs
• Inform the plant/system personnel about the duration of the
malfunction
To Next Page
Loading...
