Tucker GmbH, Mail / Post: Max-Eyth-Str.1, 35394 Gießen, Germany
56
6.3.10 Performing a Lift Check
The gun lift can be measured by holding the gun trigger for a few
seconds:
• Isolate the gun (so as not to start weld).
• Pull and hold down the trigger. The gun will lift and release for the
programmed
weld time. (Continue holding the trigger for 2 more
seconds)
• The gun will lift for 2 seconds then release. During the 2 seconds, a
manual
measurement may be taken.
To Next Page
Loading...
