Neoway M590E - Page 25

Neo_M590E V1 GPRS Module AT Command Set
Copyright © Neoway Technology Co., Ltd
20
<mt>: sets the result code indication routing for SMS-DELIVERs. The default value is 2.
0: No SMS-DELIVER indications are routed to the TE.
1: Indication of SMS-DELIVER is routed to the TE using unsolicited result code:
+CMTI: "MT"
,
<index>
. The SMS message is stored rather than directly displayed.
2: SMS-DELIVERs (except class 2 messages) are routed directly to the TE using
unsolicited result code:
+CMT :<oa>,<scts>,<tooa>,<lang>,<encod>,<priority>[,<cbn>],<length><CR><LF
><data>
(text mode). SMS messages are directly displayed rather than stored.
3: Class 3 SMS-DELIVERs are routed directly to TE using unsolicited result codes
defined in
<mt>
=2. Messages of other classes result in indication as defined in
<mt>
=1.
<bm>: sets the result code indication routing for CBMs. The default value is
0
.
0: No CBM indications are routed to the TE.
1: The cell broadcast instruction code is
+CBMI:" BC" ,<index>
and the cell broadcast
is stored.
2: Indication of new CBM is routed to the TE using unsolicited result code:
+CBM:
<oa>,[<alpha>,]<scts>[,<tooa>,<length>] <CR><LF><data>
(text mode). The cell
broadcast will be directly displayed rather than stored.
3: Class 3 CBMs are routed directly to TE using unsolicited result codes defined in
<bm>=2. Messages of other classes result in indication as defined in <bm>=1.
<ds>: sets the result code indication routing for SMS-STATUS-REPORTs. The default
value is 0.
0: No SMS-STATUS-REPORTs are routed to the TE.
1: SMS-STATUS-REPORTs are routed to the TE using unsolicited result code:
+CDS :<fo>,<mr>,[<ra>],[<tora>],<scts>, <dt>,<st>
(text mode).
<bfr>: defines the handling method for buffered result codes when <mode> 1, 2 or 3 is
enabled. The default value is 0.
0: TA buffer of unsolicited result codes defined within this command is flushed to the
TE when
<mode>
1...2 is entered (
OK
response shall be given before flushing the codes).
1: TA buffer of unsolicited result codes defined within this command is cleared when
<mode>
1...3 is entered.
Return Value
<CR><LF>OK<CR><LF>
<CR><LF>+CNMI: <mode>,<mt>,<bm>,<ds>,<bfr>
<CR><LF>OK<CR><LF>
<CR><LF>+CNMI: (list of supported <mode>s), (list of supported <mt>s), (list of
supported <bm>s), (list of supported <ds>s), (list of supported <bfr>s)
<CR><LF>OK<CR><LF>
Example
AT+CNMI=1,1,0,0,0
OK
Set the SMS message indication mode.
AT+CNMI=?
+CNMI: (0-3), (0-3), (0,2), (0-1), (0,1)
OK
Query the value ranges of the paramters.