Neoway M590E - Sending Stored SMS Messages: +CMSS

Neo_M590E V1 GPRS Module AT Command Set
Copyright © Neoway Technology Co., Ltd
25
<CR><LF>OK<CR><LF>
or
<CR><LF>ERROR<CR><LF>
Example
AT+CMGW=”091137880”<CR>
>"This is the text"<Ctrl-Z>
+CMGW: 15
OK
Text mode (+CMGF=1)
AT+CMGW=31<CR>
>0891683108705505F001000B813124248536F300081200
400026002A535A53D153A653C1532052C7<Ctrl-Z>
+CMGW: 1
OK
PDU mode (+CMGF=0)
Remarks
Press Enter or send <CR> in hexadecimal form after AT+CMGS if you use a UART
debugging tool to send PDU messages.
2.9 Sending Stored SMS Messages: +CMSS
Description
To send an SMS message specified by
<index>
in the memory (SMS-SUBMIT)
The network returns reference value
<mr>
to the end device after the SMS message is
sent successfully.
Format
AT+CMSS=<index>[,<da>[,<toda>]]<CR>
Parameter
<index>: Message location
<da>: the destination number of the SMS messages
Return Value

if text mode (+CMGF=1) and sending successful:
<CR><LF>+CMSS: <mr>[,<scts>]
<CR><LF>OK<CR><LF>

if PDU mode (+CMGF=0) and sending successful:
<CR><LF>+CMSS: <mr>[,<ackpdu>]
<CR><LF>OK<CR><LF>
Example
AT+CMSS=2
+CMSS:<mr>
OK
Send the SMS messages stored in memory 2.
AT+CMSS=2
ERROR
No SMS message is stored in memory 2 or the
SMS message number in memory 2 is incorrect.
AT+CMSS=6,"15889758495"
+CMSS: 6
OK
Forward stored SMS message to 15889758495. 6
is the ID of the message stored successfully.
Only message in text mode support this function.
Remarks
N/A