Need help?Do you have a question about the Neoway N11 V2 and is the answer not in the manual?
General| Category | Control Unit |
|---|---|
| Model | N11 V2 |
| Power Supply | DC |
| Communication Interface | UART, USB |
| Cellular Technology | GSM/GPRS |
| Frequency Bands | GSM 850/900/1800/1900 MHz |
| GPRS Class | Class 12 |
| Interfaces | UART, USB, SIM Card |
| GNSS | No |
| SIM Card | 1.8 V/3 V |
| Antenna Connector | SMA |
| Protocols | TCP/IP, UDP, HTTP, FTP |
Retrieves the module's International Mobile Equipment Identity (IMEI).
Retrieves the module's international mobile subscriber identification (IMSI).
Checks the module's network registration status.
Controls and queries GPRS network registration status.
Manages SIM card PIN and PUK codes for authentication.
Checks receiving signal strength indication (RSSI) and bit error rate (BER).
Selects and registers the module to a GSM network.
Configures the Packet Data Protocol (PDP) format for GPRS.
Configures the GPRS Access Point Name (APN).
Manages GPRS service attachment and detachment.
Reads a specific SMS message from memory.
Reads a list of SMS messages of a specific type from memory.
Sends an SMS message to a recipient.
Writes an SMS message into the module's memory.
Reads phonebook entries from a specified range of indices.
Writes contact information (number, name) to the phonebook.
Establishes a TCP connection to a specified IP address and port.
Sends TCP data over an established socket connection.
Receives TCP data from a client connection.
Establishes a UDP connection to a specified IP address and port.
Sends UDP data over an established socket connection.
Receives UDP data from a client connection.
Configures the module to listen for incoming TCP connections.
Configures the module to listen for incoming UDP connections.
Establishes a connection to an FTP server for login.
Downloads files or directory information from an FTP server.
Uploads files to an FTP server.
Establishes an HTTP connection.
Executes HTTP requests (GET, POST, HEAD).
Establishes an HTTPS connection.
Executes HTTPS requests (GET, POST, HEAD).
Connects to the MQTT server.
Subscribes to an MQTT topic.
Publishes a message to an MQTT topic.
Establishes an MQTT connection to the Ali server.
Publishes a message to an Ali MQTT topic.
Subscribes to an Ali MQTT topic.
Obtains the module's GPS location coordinates.
To Next Page
